How to assemble daniel defense buttstock?

[BobaFett]

I am currently taking off the featureless components to go the mag lock route. I cannot figure out how to put the butt stock back together so it has spring tension.

Do I have all the parts I need here?

How do you put this back together properly?

 

[AR15barrels]

The plunger and spring go in the big hole and then the roll pin goes in one side of the small hole in the lever and through the plunger and then back into the small hole on the other side of the lever.
You might be missing a 2nd roll pin.

 

[BobaFett]

oes in one side of the small

The plunger and spring go in the big hole and then the roll pin goes in one side of the small hole in the lever and through the plunger and then back into the small hole on the other side of the lever.
You might be missing a 2nd roll pin.

this is what i did earlier and i had 0 spring tension. do i have to coil down the spring and have it seated under the smaller roll pin that is not in this photo?

 

[BobaFett]

Looks like i answered my own question. You do need to push the spring down and put the smaller roll pin in first so the spring sits under it.

Fixed it guys, thanks!

 

[AR15barrels]

do i have to coil down the spring and have it seated under the smaller roll pin that is not in this photo?

Yes.

 

[BobaFett]

Thank you.