M & P Shield X roll pin's TIGHT!

[dvscycles]

The pin holding the sear block on my M&P 2.0 was tight but broke loose after some agressive tapping.
The same pin on my Shield X almost kicked my butt.
Trusty duct tape amorers block is not going to cut it any more and I might need a bigger hammer.
Going back in was almost as tough. Have some replacement pins coming since these are pretty beat up.
Yes I had good punches. I've driven 16P nails with less effort.

 

[Gawernator]

You could always try some astrolube

 

[sonofeugene]

Put a little moly paste on them. They will go in much easier. And no, they won’t come out.

 

[dvscycles]

You could always try some astrolube

Astroglide wouldnt have help getting the original pin out.

Put a little moly paste on them. They will go in much easier. And no, they won’t come out.

Yeah, I was not thinking when I put the old one back in dry.