Question Girsan MC P35 and BH Springs Solutions

[Appropriate_Sky_8043]

I have a love/hate relationship with my Girsan hi-power clone. I’ve seen on Reddit that some folks have sent theirs to be upgraded by the service dept side of BH Spring Solutions, I suspect those might be the Match version of the gun though. I’m not sure if it’s worth it to put basically the cost of the gun into upgrades - BUT, has anyone done this or just purchased the items for optimization? Did you find someone local to you to install, DIY? Thanks for your thoughts!

 

[DesertDepotArms]

Whats the issue with it?

 

[Appropriate_Sky_8043]

Whats the issue with it?

Trigger pull, largely. I did remove the mag disconnect but that seemed to have little positive impact. Of the guns I shoot, this one is the most difficult for me to find a sweet spot for consistent grouping and the noticeable difference is trigger.

 

[mrbieler]

Removing the mag disconnect doesn’t do much to help the hi power trigger. Polish the levers and their contact points. A 26 or 28lb hammer spring. Polish the sear spring where it contacts the sear. Camfer the lower edge of the sear. Getting down to a nice 5~6lb trigger isn’t too difficult but the pull and reset will never be “wow”.

 

[mrbieler]

I do like the BH Spring Solutions trigger kit a lot. Better geometry and feel.

 

[Appropriate_Sky_8043]

I do like the BH Spring Solutions trigger kit a lot. Better geometry and feel.

appreciate the info - thanks!