Icarus p320 x5 ca grip module issue

[angryasian]

I tried my to fit my Icarus p320 x5 ca grip module and I’m having a terrible time. I’ve installed the same model of grip module on multiple firearms including another p320 x5 ca. I know the tolerance is tight but still. everything seats with effort, but in order to line up the take down I have to force the fcu down in the front . I’ve managed to get that on but the slide won’t fit and I don’t want to force it. Any ideas?

 

[Gawernator]

Are you going in at an angle? I really couldn't figure out mine until I went in at an angle and got the back part to seat fully, then it finally clicked in

 

[angryasian]

Yeah, I put it in at an angle and taped it as far back as possible but no luck in the front. The take down lever just won’t fit. I’m going to slowly start taking some material in the middle inside of the grip module. It seems to be the high spot. I thought the Icarus module for my eschelon was tight. This is a whole new level. I’m worried because I got it for 250 on the Icarus sale page on their website.

 

[Gawernator]

Yeah, I put it in at an angle and taped it as far back as possible but no luck in the front. The take down lever just won’t fit. I’m going to slowly start taking some material in the middle inside of the grip module. It seems to be the high spot. I thought the Icarus module for my eschelon was tight. This is a whole new level. I’m worried because I got it for 250 on the Icarus sale page on their website.

Warranty?

 

[angryasian]

Im fairly certain I just voided it lol. Oh well. I’m going to get it to fit somehow. The factory x5 legion grip works fine. I just like the Icarus better

 

[angryasian]

Got the fcu to fit without having to force it. I had to remove material above where the weight rods go in the grip module. Pistol still not functioning correctly because there too much material in the grip and it’s squeezing the fcu in some spots.

 

[Brandon Breeze]

I tried my to fit my Icarus p320 x5 ca grip module and I’m having a terrible time. I’ve installed the same model of grip module on multiple firearms including another p320 x5 ca. I know the tolerance is tight but still. everything seats with effort, but in order to line up the take down I have to force the fcu down in the front . I’ve managed to get that on but the slide won’t fit and I don’t want to force it. Any ideas?

Sorry to hear that. I don't have anything to add for your situation, only my previous experience with Icarus. Hopefully you can get it worked out!

My only experience with Icarus was a different product. The Omega compe got G43X. It was a terrible disaster, they had terrible service, I will never buy another product from them again.

 

[angryasian]

I didn’t even try to contact them. I’ve tried in the past. It’s a gamble for sure