Radian P365 XMacro Grip

[Diabolus]

Picked this Radian backstrap + magwell combo up for my P365 XMacro.

The backstrap has deep channels and a palm swell that lock your grip in. Stock module is already fantastic, but this fills the hand a bit more without being bulky. Recoil control is better and follow-ups are easier to keep on target. There is also a small flare at the base that locks in with the pinky and that extra point of contact makes the whole grip even more solid (I have big hands).

The magwell is low profile so it does not print or snag on the draw, but the flared walls make reloads more consistent. Still takes all the factory XMacro mags and base plates, which is nice. Install is straightforward with no screws to back out. They use a dovetail and spring loaded lock so it just sits there solid, very well made.

I have been carrying and shooting it and it just works. If you run an X-Macro and want a more planted grip, this is worth it.

 

[FCRII]

Been running this since the release. It is great but must be paired with the mag base pads, trying to clear malfunctions without is a pain in the ass since you can't get a good grip to rip a mag out if needed.

 

[MrWilly]

I've been trying to like any P365 since it came to CA. It's just too small for my hands and I have to readjust my grip on every shot. Maybe this is the answer? I just wish there was a place I could test it out before sinking my hard earned money on the setup.

 

[jlane]

I've been trying to like any P365 since it came to CA. It's just too small for my hands and I have to readjust my grip on every shot. Maybe this is the answer? I just wish there was a place I could test it out before sinking my hard earned money on the setup.

It’s smaller than the large xmacro backstrap, didn’t work well for my hands. I prefer the large backstrap or the axg grip myself