Serrations/Looking for someone to do

[riceman]

As title says looking for someone to put front serrations on my glock slides.

 

[AR15barrels]

I matched the factory Glock serrations on mine when I did them.
I worked around the markings on the left side in order to keep them.
Then the slide went out to Jagerworks for their RMR cut and nitride refinish.

 

[CWINSD]

I don't know where you're located but Moreauworks in San Marcos can do the slide serrations. I had them optic cut then cerakote my Glock.

 

[jedinerd]

I matched the factory Glock serrations on mine when I did them.
I worked around the markings on the left side in order to keep them.
Then the slide went out to Jagerworks for their RMR cut and nitride refinish.

Love how this looks! Approximately what would you charge to do something like this?

 

[Custodian]

I matched the factory Glock serrations on mine when I did them.
I worked around the markings on the left side in order to keep them.
Then the slide went out to Jagerworks for their RMR cut and nitride refinish.

Can you do the top of slide to match the side serrations like the 1st gen Brownells RMR slides? Top serrations help with sight glare and help slide manipulation too.

 

[riceman]

When sending in the slide do we strip the parts or send as is?

 

[AR15barrels]

Love how this looks! Approximately what would you charge to do something like this?

$120 to cut the front serrations on both sides of a slide without refinish.
This is usually done before an RMR cut and then the whole slide gets refinished.

 

[AR15barrels]

Can you do the top of slide to match the side serrations like the 1st gen Brownells RMR slides? Top serrations help with sight glare and help slide manipulation too.

The brownells slides have angled corners where the serrations follow the angle up over the corner and connect to the top serrations.
I can cut the top and side serrations but not on the very corners like brownells.
Factory glock slides have a radius on the corners.
I do not have the ability to carry the serration around the factory corner radius.

 

[.dC0m]

When sending in the slide do we strip the parts or send as is?

Depends on the shop - some places like Jagerwerks will take it as is. I've seen other places like C&H Precision charge a small fee if you do not strip the internal parts.

 

[AR15barrels]

When sending in the slide do we strip the parts or send as is?

Assembled is fine.

 

[Gat Man]

I’ve sent a couple slides to Maple Leaf Firearms. They do slide cuts, optic cuts and nitride refinishing. I’m happy with the way my G17 turned out.

 

[gunownersradio]

You could connect with https://twosee.us/

 

[AR15barrels]

Here is a P320 slide that I cut serrations on this week.

 

[timthetwin]

I sent mine to Maple Leaf Firearms. I am very happy with the work. They have outstanding customer service.