Shield plus losing a round when ejecting

[LeonDeGamme]

I just picked up a shield plus and overall I’m impressed with the pistol. I’ve noticed a strange quirk though. If I eject a fully loaded magazine from the pistol, every once in a while, a round will pop out of the magazine and fall out while ejecting. This only happens when the slide is closed, and the magazine is full. I’ve heard a few people say that this is kind of normal for micro pistols. The pistol performs flawlessly otherwise though.

 

[RustVendor]

I would guess that since it's a ten round mag it's super tight when its full and when it strips the first round it takes the second round out halfway

 

[chancho]

I just picked up a shield plus and overall I’m impressed with the pistol. I’ve noticed a strange quirk though. If I eject a fully loaded magazine from the pistol, every once in a while, a round will pop out of the magazine and fall out while ejecting. This only happens when the slide is closed, and the magazine is full. I’ve heard a few people say that this is kind of normal for micro pistols. The pistol performs flawlessly otherwise though.

I thought it was just mine lol. I have the shield x and same thing both 10rd mags do it randomly. & a buddy with the 15rd mag says the same. The gun is still 100% no doubt.

 

[LeonDeGamme]

I would guess that since it's a ten round mag it's super tight when its full and when it strips the first round it takes the second round out halfway

It doesn’t matter if I rack the slide or not. If I insert the mag and immediately eject it, it can happen.

 

[Specialist_muted]

It's normal.

 

[Gawernator]

Is the magazine brand new? Probably just stupidly tight because of how many rounds they hold. With new mags I usually load them fully and let it sit a week or two and that always seems to kinda break them in

 

[Hindsight]

Is the magazine brand new? Probably just stupidly tight because of how many rounds they hold. With new mags I usually load them fully and let it sit a week or two and that always seems to kinda break them in

If you want to break in modern mag springs quicker, the repeated compression of the spring is what causes wear/breaks the springs in. It's a lot quicker to just load and unload each mag a few times.

 

[RustyIron]

I’ve heard a few people say that this is kind of normal for micro pistols.

Yes, I've experienced this myself on a couple pistols. When a round is being stripped off the top of the magazine, the second round is being dragged forward a little bit. Put a few miles on the pistol and magazines, and the symptom will diminish, if not disappear.

 

[mossy]

Its the spring, The shield Plus mags use stupidly stiff springs.

 

[homeslice]

The magazine disconnect lever is reaaaaally long on the shields and will kick a round forward when you quickly drop a full mag which causes this problem.

 

[LeonDeGamme]

This can happen when I put a fully loaded magazine in the firearm and immediately ejected it… Doesn’t seem to have anything to do with chambering around. Also, a friend of mine removed the mag disconnect and it’s still happening with his

 

[FCRII]

New mags, let it break in. Not anything to worry about.

 

[NorCalBusa]

Word play;
Is it still an, "accidental discharge? It unintentionally discharged a round without the trigger being pulled...